Hello,
during the amrestore I use settape to force /dev/nst0 instead of 0
(thanks Bernard).
And during recover, I answer no to :
owner/mode for '.'? [yn] n
I'll change the localhost inside the disklist
thanks to all !!
Frederic Medery
System Administrator
LexUM, University of Montreal
Bernard McAuley wrote:
Hi,
I've had the same message yesterday - I suggest you read the
/tmp/Amanda/amidxtaped.<timestamp>.debug file and post the contents. In
my case amrecover was being passed a '0' for the tapedev instead of a
suitable tape device. This was because it was picking up my chg-scsi
setup, and mapping the device name (0) instead of the device type
(/dev/nst0) to amrestore. I worked around this but using the settape
/dev/nst0 to pick up the tape device directly and avoid the /dev/sg
devices altogether which amrestore couldn't cope with.
Regards,
Bernard McAuley
bernard.mcauley < at > phyworks-ic.com
-----Original Message-----
From: owner-amanda-users < at > amanda.org
[mailto:owner-amanda-users < at > amanda.org]
On Behalf Of Frederic Medery
Sent: 28 June 2004 15:58
To: Mailing List Amanda User
Subject: amrecover problem
Hello,
When I tried to recover a folder called "my folder" (with space in it,
I
don't know if this could be the problem). I have for time to time,
Segment Fault.
and when I try to recover (when I don't receive the error) with the
extract command :
Load tape weekly-05 now
Continue [?/Y/n/s/t]? Y
EOF, check amidxtaped.<timestamp>.debug file on localhost.
amrecover: short block 0 bytes
UNKNOWN file
amrecover: Can't read file header
extract_list - child returned non-zero status: 1
Some hints ??
Thanks !!
--
Frederic Medery
System Administrator
LexUM, University of Montreal
