Category:NetBackup Command Line Interface (CLI)
From Backup Central
The following questions are in this section of the NetBackup FAQ/Wiki:
How can I change the retention period for a single image on a tape (not the entire tape)
How can I create and delete drives from the command line?
How can I see device status from the command line?
How can I verify that a certain schedule will run at a certain time?
How do I restore a tape using just the "tar" command?
How do you decipher the output of "bpdbjobs -report -all columns"?
Is there any way for me to check if all of my backup clients have all of their data protected?
Restoring an Exchange Database to a Standby server for DR or Single Mailbox Recovery
What is the format of bpstulist?
What is the format of the image name?
What is the one command that can give me ALL of the information about a backup job?
Pages in category "NetBackup Command Line Interface (CLI)"
The following 12 pages are in this category, out of 12 total.
